http://www.dopdf.com/forum/ Discussion forum for doPDF users. en Thu, 09 Feb 2012 08:12:20 +0000 http://www.dopdf.com/forum/topic/reversion-to-portrait#post-628 Thu, 19 Feb 2009 07:23:07 +0000 Softland 628@http://www.dopdf.com/forum/ <p>No problem, we haven't had reports like this in a long while, so we'll assume it was a temporary one. </p> http://www.dopdf.com/forum/topic/reversion-to-portrait#post-625 Wed, 18 Feb 2009 18:03:39 +0000 Niallo 625@http://www.dopdf.com/forum/ <p>Have been trying to make a demo file to send you, but cannot! If I make the most trivial change to the original, then the pdf is fine. I cannot send you the original because some of the contents are confidential. As I mentioned earlier, if the problem arises again, there is a workaround, and given the problem's elusive nature, I suggest that it is not worth pursuing at the moment. Thanks again for your consideration. </p> http://www.dopdf.com/forum/topic/reversion-to-portrait#post-621 Wed, 18 Feb 2009 00:35:48 +0000 Niallo 621@http://www.dopdf.com/forum/ <p>Thx for reply. I will try to make a test file, but cannot do it for a few days. </p> http://www.dopdf.com/forum/topic/reversion-to-portrait#post-615 Tue, 17 Feb 2009 07:21:57 +0000 Softland 615@http://www.dopdf.com/forum/ <p>I did some tests under Office 2003 on XP and it converts it fine. Can you send the word document in question (you can remove most of the text) to info at dopdf dot com? And are you creating it from Office 2007 on Vista? </p> http://www.dopdf.com/forum/topic/reversion-to-portrait#post-612 Mon, 16 Feb 2009 16:00:42 +0000 Niallo 612@http://www.dopdf.com/forum/ <p>I am using version 6.2.288 </p> http://www.dopdf.com/forum/topic/reversion-to-portrait#post-609 Mon, 16 Feb 2009 08:25:13 +0000 Softland 609@http://www.dopdf.com/forum/ <p>Thanks for posting the workaround, but still the pdf should display correctly without inserting page breaks. I know this was a bug in a previous version of dopdf, so my question is if you are using the latest version? </p> http://www.dopdf.com/forum/topic/reversion-to-portrait#post-607 Mon, 16 Feb 2009 01:07:32 +0000 Niallo 607@http://www.dopdf.com/forum/ <p>OK I've found a workaround. Instead of allowing a long WORD table to make its own page breaks, insert explicit section breaks with defined Landscape aspect. </p> http://www.dopdf.com/forum/topic/reversion-to-portrait#post-606 Sun, 15 Feb 2009 19:24:38 +0000 Niallo 606@http://www.dopdf.com/forum/ <p>I am having trouble converting a WORD file to pdf. The Word file has two sections, the first is Portrait, the second, Landscape. The pdf output correctly shows the first section in portrait, but only the first page of the second section in landscape. Then it reverts to portrait for the remainder of the section.<br /> Any suggestions? </p>